Bionx Controls

BionX Throttle Module for G2 controller. Please note that actual cables length is about 18cm and is not as pictured in the 1st picture. Extended ca...

RC3 Throttle (3rd Generation controller). Short cable version (01-5590) for downtube batteries.RC3 only (no brake switch 2.5mm cable included) Comp...

BionX Docking Station for G2 controller. Receptacle only no G2 controller included. no clips, no rubbers, no screws, as pictured. A few length op...

G2 Controller, Black, Comes pre-programmed with firmware rev 64.2Code 3773 is functional. Please carefully look at the rear contacts picture. As so...

RC3 Throttle (3rd Generation controller).Long cable length for rear rack batteries.Only the RC3 throttle included. Does not comes with 3.5mm brake ...

DS3 Display Kit Assembly (With docking and center arm) Includes;01-5564 - DS301-5780 - DS3 Dock, Center mount,  and shims. Must be used with RC3 an...

BionX Trek RIDE+ Pro Controller usually used on Trek bicycles. It is using the same docking as the G2 controller 01-3205 and can be used on non Tre...

This is the first BionX G1 classic controller. For CAN bus system (not for older I2C) There is no throttle lever on this one, only assist/regen le...

RC3 Brake Switch, 2.5mm Jack. Normally closed. To be used with RC3 controllers. Can be purchased without the adhesive foam holder 01-5940 Or with t...

Service Kit - Docking Station for all G2 controllers.Includes; 1x Console Receptacle. Different wire lengths available;.  01-4451, 10.7CM cable d...

** RC3 and DS3 are only compatible with 48 volts batteries. (not 36v or less)  This is an upgrade kit to replace older G1 or G2 controllers. The 01...

BionX Smart Bikes G2 controller docking station, 01-4261 Specifically used on Smart E-bike based using BionX technology Will accept BionX G2 cont...

G2 controllers Reed Switch Assembly. - Normally Closed, 17.5cm. - No magnet included. No foam adhesive included; 01-1283 With form adhesive include...

BionX Docking station assembly for DS3 display. Comes with; DS3 Docking with 3.5mm jack. Left and right plastic arms 3 set of shims with different...

DS3 color Display (3rd Generation color Display). Features include: Transflective color display Quarter-turn mounting mechanism Protective rubber ...

Reed Switch Adhesive Mount. For all BionX brake sensors. Two version are available; 01-1287A; For G2 brake switch. Standard hole size 01-1287B; For...

G2 consoles Central Mount docking station. With 6X rubber shims (No G2 controller included)

BionX Docking Station for RIDE+ EASY1 and EASY2 smaller controllers usually found on Trek bicycles. No EASY I or II controller included! (as pictur...

BionX G2 throttle for Trek RIDE+ Pro bikes. - This throttle is usually used with Trek RIDE+ Pro controller.- Comes with a 2.5mm audio jack connecto...

This is for a USED controller.  100% tested and functional. This is the first BionX G1 classic controller. For CAN bus system throttle lever insta...

BionX Docking Station for FRONT MOTOR bikes.Usually used on European TREK bikes.  ONLY COMPATIBLE WITH FRONT MOTOR SYSTEMS. COMPATIBLE WITH G2 ...