Products

** RC3 and DS3 are only compatible with 48 volts batteries. (not 36v or less)  This is an upgrade kit to replace older G1 or G2 controllers. The 01...

This is the first BionX G1 classic controller. For CAN bus system (not for older I2C) There is no throttle lever on this one, only assist/regen le...

DS3 color Display (3rd Generation color Display). Features include: Transflective color display Quarter-turn mounting mechanism Protective rubber ...

BionX Docking Station for FRONT MOTOR bikes.Usually used on European TREK bikes.  ONLY COMPATIBLE WITH FRONT MOTOR SYSTEMS. COMPATIBLE WITH G2 ...

BionX G2 throttle for Trek RIDE+ Pro bikes. - This throttle is usually used with Trek RIDE+ Pro controller.- Comes with a 2.5mm audio jack connecto...

BionX Throttle Module for G2 controller. Please note that actual cables length is about 18cm and is not as pictured in the 1st picture. Extended ca...

BionX Trek RIDE+ Pro Controller usually used on Trek bicycles. It is using the same docking as the G2 controller 01-3205 and can be used on non Tre...

DS3 Display Kit Assembly (With docking and center arm) Includes;01-5564 - DS301-5780 - DS3 Dock, Center mount,  and shims. Must be used with RC3 an...

G2 Controller, Black, Comes pre-programmed with firmware rev 64.2Code 3773 is functional. Please carefully look at the rear contacts picture. As so...

RC3 Throttle (3rd Generation controller). Short cable version (01-5590) for downtube batteries.RC3 only (no brake switch 2.5mm cable included) Comp...

RC3 Throttle (3rd Generation controller).Long cable length for rear rack batteries.Only the RC3 throttle included. Does not comes with 3.5mm brake ...

This is for a USED controller.  100% tested and functional. This is the first BionX G1 classic controller. For CAN bus system throttle lever insta...